Suitcase: the Package Comes in a Suitcase, so You Can Store and Carry Them Easily and Don't Lose the Machine Parts. This Machine Is Suitable for Threading Galvanized Pipes, Iron Pipes, Pp Pipes, and Tubes. It Is Suitable for Threading Various Water, Electric, or Gas Pipes from 20.9mm to 49.6mm. Threading Range: 20.9-49.6mm/0.5-2in.
Material: All Copper Wire Machine. Voltage: 110 V, 50 Hz.
Rated Spindle Speed: 25 (R/Min). Size: 1/2, 3/4, 1, 1-1 / 4, 1-1 / 2, 2 (Inch). Product Dimensions : 57x14 X31cm/22.44x5.51x12.2in.
Outer Pipe Diameter: 22,27,34,42,48,60mm. Inner Pipe Diameter: 15,20,25,32,40,50mm. You Should Select the Corresponding Die Head. The Blade Is Installed from the Right on the Host.
Clamp the Tube to Approximately the Same Length As the Arm (L2 Is Approximately Equal to L1). Turn the Front and Rear Switches to the down Arrow Position to Start the Switch and Auxiliary Contacts. For Hard Pipes Such As Stainless Steel Pipes, Galvanized Pipes, Brass When Refueling in Time, Plastic Pipes Without Fuel.Note That the Tube Holder Can Not Be Touched with the Host During the Right Shift, Otherwise It Will Hurt the Host. After the Machine Stopped, Pull up the Reverse Switch and Exit the Tube. This Product Supports the Use of Standard Tubes. Do not directly change the direction of the machine during rotation.
Lubricating oil should be added during use. The pipe must be fixed firmly and cannot rotate with the machine. If there is abnormal heating or smoke, power off in time and continue to use after cooling. Add the Lubricating Oil Every Time You Use It.
Please Allow 1-3 Cm Error Due to Manual Measurement. Feedback is very important to us. It is impossible to address issues if we do not know about them!Faction is our ultimate goal. We work hard to earn your trust and future business.
A If you receive a defective item, you may return it or ask for a discount. Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday.