110V Pipe Cutter Tool Electric Pipe Threader Pipe Threading Machine 2300W. 110v Pipe Cutter Tool Electric Pipe Threader Pipe Threading Machine 2300w.
Do not directly change the direction of the machine during rotation. Lubricating oil should be added during use. The pipe must be fixed firmly and cannot rotate with the machine. If there is abnormal heating or smoke, power off in time and continue to use after cooling.
The Plug Is Eu Plug. 2300w 50hz 25 R / Min Electric Tapping Machine Pipe Cutter 1/2, 3/4, 1, 1-1 / 4, 1-1 / 2, 2 Inch. Compact Hand Design: the Compact Hand Design on the Handle Saves Your Labor and Doesn't Make You Feel Fatigued Easily.
It Also Prevents the Machine from Falling. High Quality: This Machine Is Made of Pure Copper, It Is Durable and Doesn't Break Easily. Copper Is an Ideal Material for the Threading Machine. Powerful Motor: the Motor of This Machine Is 2300w and Has a High Work Efficiency to save Your Working Time. Six Dies: the Package Comes with Six Dies with the Machine, They Can Meet Your Different Demands for Different Tasks.Tube Holder: You Can Fix the Tube on the Tube Holder, It Can Help You with the Pipes and You Can Work More Conveniently. Fixed Rod: the Rod Can Help You Fix the Pipe and Make the Pipe Attached to Each Other As to How You Want Them to Be. You Can Have a Better Work Performance with This Rod. Suitcase: the Package Comes in a Suitcase, so You Can Store and Carry Them Easily and Don't Lose the Machine Parts. This Machine Is Suitable for Threading Galvanized Pipes, Iron Pipes, Pp Pipes, and Tubes. It Is Suitable for Threading Various Water, Electric, or Gas Pipes from 20.9mm to 49.6mm.
Threading Range: 20.9-49.6mm/0.5-2in. Material: All Copper Wire Machine.
Voltage: 110 V, 50 Hz. Rated Spindle Speed: 25 (R/Min). Size: 1/2, 3/4, 1, 1-1 / 4, 1-1 / 2, 2 (Inch). Product Dimensions : 57x14 X31cm/22.44x5.51x12.2in.Outer Pipe Diameter: 22,27,34,42,48,60mm. Inner Pipe Diameter: 15,20,25,32,40,50mm. You Should Select the Corresponding Die Head. The Blade Is Installed from the Right on the Host.
Clamp the Tube to Approximately the Same Length As the Arm (L2 Is Approximately Equal to L1). Turn the Front and Rear Switches to the down Arrow Position to Start the Switch and Auxiliary Contacts. For Hard Pipes Such As Stainless Steel Pipes, Galvanized Pipes, Brass When Refueling in Time, Plastic Pipes Without Fuel. Note That the Tube Holder Can Not Be Touched with the Host During the Right Shift, Otherwise It Will Hurt the Host.
After the Machine Stopped, Pull up the Reverse Switch and Exit the Tube. This Product Supports the Use of Standard Tubes. Add the Lubricating Oil Every Time You Use It. Please Allow 1-3 Cm Error Due to Manual Measurement.